Datasheet

ManualsBrands3M ManualsAdhesive TapesExtreme Sealing Tape, 50mm x 16.5m, Translucent White

Extreme Sealing Tape

4412N

Technical Data September, 2010

Product Description 3M™ Extreme Sealing Tape 4412N is a single coated, pressure sensitive adhesive

tape designed for difficult sealing applications. The backing on this tape is an

ionomer film that is very tough yet flexible and abrasion resistant. The very soft and

thick acrylic adhesive has excellent sealing properties and good long term, outdoor

durability. This single coated tape is designed to seal over an existing joint, seam, or

penetration. The adhesive is designed to adhere well to the ionomer film so that

overlap layers of this tape can be used and still provide a tight seam to itself and the

joint or seam to be sealed.

Construction

Protective Liner

Ionomer Backing

Adhesive

Protective Release Liner: 3 mils thick (0.08 mm), matte finish, translucent, polyester film

Ionomer Backing: 4 mils thick (0.1 mm), acrylic and ethylene copolymer

Adhesive: 75 mils thick (1.9 mm), very conformable multi-purpose acrylic

Total Tape Thickness: 79 mils thick (2.0 mm) without disposable release liner

Summary of content (4 pages)

PAGE 1
Extreme Sealing Tape 4412N Technical Data Product Description September, 2010 3M™ Extreme Sealing Tape 4412N is a single coated, pressure sensitive adhesive tape designed for difficult sealing applications. The backing on this tape is an ionomer film that is very tough yet flexible and abrasion resistant. The very soft and thick acrylic adhesive has excellent sealing properties and good long term, outdoor durability.
PAGE 2
3M Extreme Sealing Tape TM 4412N Typical Physical Properties and Performance Characteristics Note: The following technical information and data should be considered representative or typical only and should not be used for specification purposes. Tape Color: Translucent white 51 lb/ft3 (0.82 g/cm3) Tape Density: Tape Tensile Strength: 13.4 lbs/in tape width (23.
PAGE 3
M Extreme Sealing Tape TM 4412N Application Guidelines Depending on the surfaces to be sealed, one of three basic surface preparations will be required: 1) Good cleaning with a 50:50 mixture of isopropyl alcohol* and water to remove contaminants; 2) Fine abrading with a 180x grit or finer abrasive followed by good cleaning with a 50:50 mixture of isopropyl alcohol* and water; or 3) Good cleaning with a 50:50 mixture of isopropyl alcohol* and water followed by application of an adhesion promoter or primer
PAGE 4
3M Extreme Sealing Tape TM 4412N Storage Store in original cartons at 40-100°F (4-38°C) and 0-95% relative humidity. Optimum storage conditions are 72°F (22°C) and 50% relative humidity. Shelf Life When stored under proper conditions, product retains its performance and properties for 24 months from date of manufacture. The date of manufacture is listed as a run number beginning with the letter “K” and followed by a 5 digit Julian calendar code (YYDDD).