Datasheet

Use Limitation
Thisrespiratordoesnotsupplyoxygen.Donotusein
atmospherescontaininglessthan19.5%*oxygen.
1. Donotuseforrespiratoryprotectionagainstatmospheric
contaminants that have poor warning properties or are
unknownorimmediatelydangeroustolifeandhealth(IDLH)
or against contaminants which generate high heats of reaction
with chemical filters.
2. Donotmisuse,alter,modifyorrepairthisproduct.
3. Donotusewithbeardsorotherfacialhairthatpreventdirect
contact between face and edge of the respirator.
4. Donotusewithunknownconcentrationsofcontaminants.
5. Donotuseforescapepurposes.
6. Leavetheworkareaimmediatelyandchecktheintegrityof
the respirator and replace face mask if:
- Damagehasoccurredorisapparent.
- Breathingbecomesdicultorincreasedbreathing
resistance occurs.
- Dizzinessorotherdistressoccurs.
- You taste or smell the contaminant or an irritation occurs.
7. Storethisdeviceinasealedcontainerawayfrom
contaminated areas when not in use.
8. Usestrictlyinaccordancewithrespiratorandlteruser
instruction leaflet.
9. Incaseofintendeduseinexplosiveatmospheres,contact3M
technical service.
*3Mdefinitionminimum19.5%byvolumeoxygen
Fitting Instructions
Beforeassigninganyrespiratortobeworninacontaminated
area, we recommend that a qualitative or quantitative fit check be
performed before entering the workplace.
Fitting instructions must be followed each time the respirator is
worn.
1. Assemble/adjustheadcradlebyfeedingtheperforatedstrip
through the buckle and pressing down on the stud at the
required length. Repeat for second strip.
2. Placetherespiratorovertheface,ttingitcomfortablyon
bridge of the nose, then pull the head harness over the crown
of the head.
3. Ifnecessaryremovetherespiratorandreadjustthehead
cradletoacomfortabletandrepeatstep2.
4. Take a bottom strap in each hand, place them at the back of
the neck and hook the straps together
5. Tightenthetopheadharnessrstbypullingontheendsto
achieve a comfortable and secure fit. Tighten bottom straps in
a similar manner. Strap tension may be decreased by pushing
out on back side of buckles.
6. (Whereapplicable)Aftertighteningtheheadharness(see5),
slide the 4 plastic