MSDS

MATERIAL SAFETY DATA SHEET 3M™ Bondo(r) Home Solutions™ Fiberglass Resin Liquid Hardener, 20126 01/21/10
_________________________________________________________________________________________________
Page 4 of 8
children. Avoid breathing of dust created by cutting, sanding, grinding or machining. Avoid contact with oxidizing agents.
7.2 STORAGE
Store away from acids. Store away from heat. Store out of direct sunlight. Keep container tightly closed. Store away from oxidizing
agents. Store in a cool, dry place.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1 ENGINEERING CONTROLS
Provide appropriate local exhaust for cutting, grinding, sanding or machining. Use in a well-ventilated area. Use general dilution
ventilation and/or local exhaust ventilation to control airborne exposures to below Occupational Exposure Limits and/or control mist,
vapor, or spray. If ventilation is not adequate, use respiratory protection equipment.
8.2 PERSONAL PROTECTIVE EQUIPMENT (PPE)
8.2.1 Eye/Face Protection
Avoid eye contact. Avoid eye contact with vapors, mists, or spray.
The following eye protection(s) are recommended: Indirect Vented Goggles.
8.2.2 Skin Protection
Avoid skin contact.
Select and use gloves and/or protective clothing to prevent skin contact based on the results of an exposure assessment. Consult with
your glove and/or protective clothing manufacturer for selection of appropriate compatible materials.
Gloves made from the following material(s) are recommended: Nitrile Rubber, Polyethylene/Ethylene Vinyl Alcohol.
8.2.3 Respiratory Protection
Avoid breathing of vapors, mists or spray. Avoid breathing of dust created by cutting, sanding, grinding or machining.
Select one of the following NIOSH approved respirators based on airborne concentration of contaminants and in accordance with
OSHA regulations: Fullface supplied-air respirator, Half facepiece or fullface air-purifying respirator with organic vapor cartridges
and P95 particulate prefilters. Consult the current 3M Respiratory Selection Guide for additional information or call 1-800-243-4630
for 3M technical assistance.
8.2.4 Prevention of Swallowing
Do not eat, drink or smoke when using this product. Wash exposed areas thoroughly with soap and water.
8.3 EXPOSURE GUIDELINES
Ingredient Authority Type Limit Additional Information
DIMETHYL PHTHALATE ACGIH TWA 5 mg/m3
DIMETHYL PHTHALATE OSHA TWA 5 mg/m3 Table Z-1
HYDROGEN PEROXIDE ACGIH TWA 1 ppm Table A3
HYDROGEN PEROXIDE OSHA TWA 1 ppm Table Z-1
METHYL ETHYL KETONE ACGIH TWA 200 ppm
METHYL ETHYL KETONE ACGIH STEL 300 ppm
METHYL ETHYL KETONE OSHA TWA 200 ppm Table Z-1A
METHYL ETHYL KETONE OSHA STEL 300 ppm Table Z-1A
METHYL ETHYL KETONE PEROXIDE ACGIH CEIL 0.2 ppm
METHYL ETHYL KETONE PEROXIDE OSHA CEIL 0.7 ppm Table Z-1A
SOURCE OF EXPOSURE LIMIT DATA:
ACGIH: American Conference of Governmental Industrial Hygienists
CMRG: Chemical Manufacturer Recommended Guideline