MSDS

MATERIAL SAFETY DATA SHEET SHARPSHOOTER(TM) EXTRA STRENGTH NO RINSE MARK REMOVER 03/30/11
_________________________________________________________________________________________________
Page 3 of 7
Autoignition temperature
Not Applicable
Flash Point
Not Applicable
Flammable Limits(LEL)
Not Applicable
Flammable Limits(UEL)
Not Applicable
5.2 EXTINGUISHING MEDIA
Non-combustible. Choose material suitable for surrounding fire.
5.3 PROTECTION OF FIRE FIGHTERS
Special Fire Fighting Procedures: Wear full protective equipment (Bunker Gear) and a self-contained breathing apparatus (SCBA).
Unusual Fire and Explosion Hazards: Contact with aluminum or zinc in a pressurized system may generate hydrogen gas which
could create an explosion hazard. Non-flammable: ordinary combustible material.
Note: See STABILITY AND REACTIVITY (SECTION 10) for hazardous combustion and thermal decomposition
information.
SECTION 6: ACCIDENTAL RELEASE MEASURES
6.1. Personal precautions, protective equipment and emergency procedures
6.2. Environmental precautions
Clean-up methods
Refer to other sections of this MSDS for information regarding physical and health hazards, respiratory protection, ventilation, and
personal protective equipment. Call 3M-HELPS line (1-800-364-3577) for more information on handling and managing the spill.
Clean up residue with water.
In the event of a release of this material, the user should determine if the release qualifies as reportable according to
local, state, and federal regulations.
SECTION 7: HANDLING AND STORAGE
7.1 HANDLING
Do not eat, drink or smoke when using this product. Wash exposed areas thoroughly with soap and water. Keep away from aluminum
and zinc. Avoid breathing of vapors, mists or spray. Keep out of the reach of children. Avoid skin contact. Avoid eye contact.
7.2 STORAGE
Store away from areas where product may come into contact with food or pharmaceuticals. Store under normal warehouse conditions.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1 ENGINEERING CONTROLS
Use in an enclosed process area is recommended. Use in a well-ventilated area. Do not use in a confined area or areas with little or
no air movement.
8.2 PERSONAL PROTECTIVE EQUIPMENT (PPE)