Datasheet

ManualsBrands3M ManualsCable Accessories17017CLR Clip Self-adhesive Bundle Ø range 5 mm (max) Transparent 4 pc(s)

To Mount:

1. To obtain optimum adhesion, the bonding surface must be clean and dry. Clean surface with

isopropyl rubbing alcohol, wipe gently and let dry. Do not use household cleaners.

2. Separate the strips and remove the red liner. Press adhesive to back of hook or clip.

3. Remove black liner. Press the hook to the surface firmly for 10 seconds.

4. For hooks with a separate back plate, slide the hook up to remove from the back plate.

5. Press the back plate firmly for 30 seconds. Bond strength will depend upon the amount of adhesive-

to-surface contact developed.

6. Slide the hook back onto the back plate.

7. Wait one hour before hanging items.

To Remove:

1. Slide the hook up to remove it from the back plate.

2. Hold the top of the back plate gently against the surface.

3. Grab removal tab and SLOWLY stretch straight down along the wall at least 12 inches until the back

plate and the strip release from the surface. NEVER pull the strip towards you.

Notes:

• Failure to follow instructions carefully may result in damage

• Do not use with wallpaper

• May not adhere well to vinyl surfaces

• DO NOT use for antiques, heirlooms, or other valuable or irreplaceable items

• DO NOT hang objects over beds

• Use only one hook per item hung

• Apply to surfaces above 50° F (10° C)

• Adhesive could soften and lose adhesion above 105° F (40°C)

• Not for use in direct sunlight

• Not for use in wet environments

• Will not adhere to dirty, dusty, or oily surfaces

• Wait at least 7 days to apply to freshly painted surfaces

• Not recommended for use on bare wood or porous, unpainted surfaces

• Holding capacity is reduced if the load is applied less than one hour after the adhesive

has been applied

Call 1-800-934-7355 or 1-800-3M HELPS (1-800-364-3577) for technical service assistance and

additional information.

3M Construction and Home

Improvement Markets Division

3M Center, Building 251-1C-09

St. Paul, MN 55144-1000

IMPORTANT NOTICE: All statements, technical information and recommendations herein are based

on tests 3M believes to be reliable. 3M does not warrant or guarantee the accuracy or completeness

of this information. THE FOLLOWING IS MADE IN LIEU OF ALL WARRANTIES, EXPRESS OR

IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY

OR FITNESS FOR A PARTICULAR PURPOSE: 3M’s only obligation shall be to replace such quantity

of thi

s 3M product proved to be defective. User is responsible for determining whether this 3M product

is fit for a particular purpose and suitable for user’s method of application. Because there are many

factors that can affect the use and performance of this product, some of which are uniquely within the

user’s knowledge and control, it is essential that the user evaluate this product to determine whether it

is fit for a particular purpose, is suitable for the user’s method of application, and meets the user’s

performance specifications and expectations.

Limitation of Liability: 3M SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGES, WHETHER

DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL (INCLUDING BUT NOT

LIMITED TO LOST PROFITS, BUSINESS, OR REVENUES) ARISING OUT OF THE USE OF OR

INABILITY TO USE THIS 3M PRODUCT, WARRANTY, OR STRICT LIABILITY. No statement or

recommendation not contained herein shall have any force or effect unless contained in an agreement

signed by a 3M officer..

3M, Command, and the Plaid Design are trademarks of 3M Company.