3M™ Accuspray™ System HVLP Spray Gun 3M™ PPS™ Paint Preparation System Improve Productivity Reduce Waste 3M™ Accuspray™ System is the equivalent of having a brand new HVLP spray gun for a fraction of the cost with each disposable nozzle replacement. 3M™ PPS™ Paint Preparation System is an innovative system for mixing and spraying both solvent based and waterborne materials.
How The System Works 1 Hand tighten or use two wrenches to connect the air flow control value. 7 Flush out atomizing head with appropriate solvent until the atomizing head is clear of coating.
Technical Data Weight 11.4 oz Nozzle Size 1.4 mm, 1.8 mm, 2.0 mm Operating Pressure (Full Trigger) 20 psi max Air Consumption 10 cfm 4 Set air pressure at 20 psi at full trigger (air and fluid flowing). 10 Inspect atomizing head for damage or wear which could result in fluid leaks or poor performance. 5 Adjust fan and fluid flow to achieve the desired size and wetness of the pattern. NOTE: when closing the fan adjustment completely it may be necessary to re-adjust the air flow control valve.
3M™ PPS™ Paint Preparation System An innovative system from 3M which enables painters to mix less paint and drastically reduces the amount of solvent and technician time required for gun cleaning, improving operator efficiency by as much as 15%. 3M™ PPS™ Paint Preparation System is a unique, closed paint system which eliminates the need for traditional mixing cups and paint strainers. Now, paint can be mixed and sprayed out of the same 3M™ PPS™ liner with a lid and built-in filter.
9a 9b Spray gun with correct adapter is attached with a quick quarter turn. Make sure that the lid fingers are fully engaged above adapter edge. 12 To return material back into gun cup before disconnecting spray gun, disconnect air line, invert gun (gravity feed only) and pull trigger fully for a few seconds. 16 13 Remaining material can be capped and stored for later use. Storage of paint should follow all local regulations. 10 11 The spray gun is now ready to spray as normal.
It’s Easy as Click and Spray Reduces Overspray Improves Transfer Efficiency Decreases Sanding Time Reduces Solvent Consumption Lowers Coating Consumption Flatter Smoother Finish This revolutionary product allows you to have a brand new spray gun on demand. The innovative technology was designed from the inside out for the efficient and economical application of material. These atomizing heads deliver a large usable pattern, with very low overspray and exceptional atomization.
Part No.
3M™ Accuspray™ Family of Products Chart Woodworking Latex Paints, Adhesives General Industrial Epoxies, Undercoatings, Hi-build Primers 1.8 mm Interchangeable Nozzle Size Fluid Tip Transportation (Air and Wheeled) Undercoatings, Adhesives, Specialty Coatings 3M™ Accuspray™ Spray Gun Model HGP (Pressure), PN 16587 Medium Viscosity Marine & Composites Gel Coats, Adhesives, Base Coats, Primers Woodworking Stains, Base Coats, Lacquers General Industrial Primers, Base Coats, Adhesives 2.0 mm 1.8 mm 1.
