Datasheet

Silicone Lubricant
__________________________________________________________________________________________
Page: 4 of 11
ventilation, and personal protective equipment.
6.2. Environmental precautions
Avoid release to the environment.
6.3. Methods and material for containment and cleaning up
If possible, seal leaking container. Place leaking containers in a well-ventilated area, preferably an operating exhaust hood, or
if necessary outdoors on an impermeable surface until appropriate packaging for the leaking container or its contents is
available. Contain spill. Cover spill area with a fire-extinguishing foam designed for use on solvents, such as alcohols and
acetone, that can dissolve in water. An AR-AFFF type foam is recommended. Working from around the edges of the spill
inward, cover with bentonite, vermiculite, or commercially available inorganic absorbent material. Mix in sufficient absorbent
until it appears dry. Remember, adding an absorbent material does not remove a physical, health, or environmental hazard.
Collect as much of the spilled material as possible using non-sparking tools. Place in a metal container approved for
transportation by appropriate authorities. Clean up residue with an appropriate solvent selected by a qualified and authorised
person. Ventilate the area with fresh air. Read and follow safety precautions on the solvent label and Safety Data Sheet. Seal
the container. Dispose of collected material as soon as possible.
6.4. Reference to other sections
Refer to Section 8 and Section 13 for more information
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Avoid breathing of vapours created during the cure cycle. Do not use in a confined area with minimal air exchange. Keep
out of reach of children. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open
flame or other ignition source. Do not pierce or burn, even after use. Do not breathe dust/fume/gas/mist/vapours/spray.
Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when using this product. Wash thoroughly after
handling. Avoid contact with oxidising agents (eg. chlorine, chromic acid etc.)
7.2. Conditions for safe storage including any incompatibilities
Store in a well-ventilated place. Keep container tightly closed. Protect from sunlight. Do not expose to temperatures
exceeding 50C/122F. Store away from heat. Store away from acids. Store away from oxidising agents.
7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
If a component is disclosed in section 3 but does not appear in the table below, an occupational exposure limit is not available
for the component.
Ingredient
CAS Nbr
Agency
Limit type
Additional comments
Butane
106-97-8
UK HSC
TWA:1450 mg/m³(600
ppm);STEL:1810 mg/m³(750
ppm)
UK HSC : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
CEIL: Ceiling
Biological limit values
No biological limit values exist for any of the components listed in Section 3 of this safety data sheet.