SDS

3M(TM) Marine Fiberglass Restorer and Wax, P.N. 09005, 09005F, 09005I; 09006, 09006E; 09007, 09007E 06/06/16
__________________________________________________________________________________________
Page 5 of 11
STEL: Short Term Exposure Limit
CEIL: Ceiling
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapors/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face
protection(s) are recommended:
Safety Glasses with side shields
Skin/hand protection
Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the
results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the
substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions.
Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective
clothing.
Gloves made from the following material(s) are recommended: Neoprene
Respiratory protection
An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of
a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator
type(s) to reduce inhalation exposure:
Half facepiece or full facepiece air-purifying respirator suitable for organic vapors and particulates
For questions about suitability for a specific application, consult with your respirator manufacturer.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
General Physical Form:
Liquid
Specific Physical Form:
Paste
Odor, Color, Grade:
Mild solvent odor tan to beige color
Odor threshold
No Data Available
pH
8 - 8.5
Melting point
Not Applicable
Boiling Point
150 - 212 ºF
Flash Point
150 ºF [Test Method: Pensky-Martens Closed Cup]
Evaporation rate
>=1 [Ref Std: WATER=1]
Flammability (solid, gas)
Not Applicable
Flammable Limits(LEL)
No Data Available
Flammable Limits(UEL)
No Data Available
Vapor Pressure
<=16 mmHg
Vapor Density
>=1.00 [Ref Std: AIR=1]
Density
1.14 g/ml
Specific Gravity
1.14 [Ref Std: WATER=1]
Solubility in Water
Appreciable
Solubility- non-water
No Data Available
Partition coefficient: n-octanol/ water
No Data Available