MSDS

MATERIAL SAFETY DATA SHEET 3M(TM) Plastic and Emblem Adhesive - Clear, P.N. 08061 03/20/09
_________________________________________________________________________________________________
Page 4 of 8
dilution ventilation and/or local exhaust ventilation to control airborne exposures to below Occupational Exposure Limits. If
ventilation is not adequate, use respiratory protection equipment.
7.2 STORAGE
Store away from acids. Store away from heat. Store out of direct sunlight. Keep container in well-ventilated area. Keep container
tightly closed. Store away from oxidizing agents.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1 ENGINEERING CONTROLS
Use with appropriate local exhaust ventilation. Provide appropriate local exhaust ventilation on open containers. If exhaust
ventilation is not available, use appropriate respiratory protection. Do not use in a confined area or areas with little or no air
movement. Provide ventilation adequate to maintain dust concentration below minimum explosive concentrations. Use general
dilution ventilation and/or local exhaust ventilation to control airborne exposures to below Occupational Exposure Limits and/or
control mist, vapor, or spray. If ventilation is not adequate, use respiratory protection equipment.
8.2 PERSONAL PROTECTIVE EQUIPMENT (PPE)
8.2.1 Eye/Face Protection
Avoid eye contact with vapors, mists, or spray.
The following eye protection(s) are recommended: Safety Glasses with side shields, Indirect Vented Goggles.
8.2.2 Skin Protection
Avoid skin contact.
Select and use gloves and/or protective clothing to prevent skin contact based on the results of an exposure assessment. Consult with
your glove and/or protective clothing manufacturer for selection of appropriate compatible materials.
Gloves made from the following material(s) are recommended: Butyl Rubber, Polyethylene/Ethylene Vinyl Alcohol.
8.2.3 Respiratory Protection
Avoid breathing of vapors, mists or spray.
Select one of the following NIOSH approved respirators based on airborne concentration of contaminants and in accordance with
OSHA regulations: Half facepiece or fullface air-purifying respirator with organic vapor cartridges and P95 particulate prefilters.
Consult the current 3M Respiratory Selection Guide for additional information or call 1-800-243-4630 for 3M technical assistance.
8.2.4 Prevention of Swallowing
Do not eat, drink or smoke when using this product. Wash exposed areas thoroughly with soap and water. Not applicable.
8.3 EXPOSURE GUIDELINES
Ingredient Authority Type Limit Additional Information
METHYL ETHYL KETONE ACGIH TWA 200 ppm
METHYL ETHYL KETONE ACGIH STEL 300 ppm
METHYL ETHYL KETONE OSHA TWA 200 ppm Table Z-1A
METHYL ETHYL KETONE OSHA STEL 300 ppm Table Z-1A
SOURCE OF EXPOSURE LIMIT DATA:
ACGIH: American Conference of Governmental Industrial Hygienists
CMRG: Chemical Manufacturer Recommended Guideline
OSHA: Occupational Safety and Health Administration
AIHA: American Industrial Hygiene Association Workplace Environmental Exposure Level (WEEL)