SDS

3M™ Plastic and Emblem Adhesive - Clear PN 03601 & 33601 08/03/22
__________________________________________________________________________________________
Page 5 of 15
8.1. Control parameters
Occupational exposure limits
If a component is disclosed in section 3 but does not appear in the table below, an occupational exposure limit is not available
for the component.
Ingredient
C.A.S. No.
Agency
Limit type
Additional Comments
Methyl isobutyl ketone
108-10-1
ACGIH
TWA:20 ppm;STEL:75 ppm
A3: Confirmed animal
carcin.
Methyl isobutyl ketone
108-10-1
OSHA
TWA:410 mg/m3(100 ppm)
Toluene
108-88-3
ACGIH
TWA:20 ppm
A4: Not class. as human
carcin, Ototoxicant
Toluene
108-88-3
OSHA
TWA:200 ppm;CEIL:300 ppm
Hexane
110-54-3
ACGIH
TWA:50 ppm
Danger of cutaneous
absorption
Hexane
110-54-3
OSHA
TWA:1800 mg/m3(500 ppm)
Methylene Chloride
75-09-2
ACGIH
TWA:50 ppm
A3: Confirmed animal
carcin.
Methylene Chloride
75-09-2
OSHA
TWA:25 ppm;STEL:125 ppm
29 CFR 1910.1052,
SKIN
Methyl Ethyl Ketone
78-93-3
ACGIH
TWA:200 ppm;STEL:300 ppm
Methyl Ethyl Ketone
78-93-3
OSHA
TWA:590 mg/m3(200 ppm)
ACGIH : American Conference of Governmental Industrial Hygienists
AIHA : American Industrial Hygiene Association
CMRG : Chemical Manufacturer's Recommended Guidelines
OSHA : United States Department of Labor - Occupational Safety and Health Administration
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
CEIL: Ceiling
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapors/spray. If ventilation is not adequate, use respiratory protection equipment.
Use explosion-proof ventilation equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face
protection(s) are recommended:
Full Face Shield
Indirect Vented Goggles
Skin/hand protection
Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the
results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the
substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions.
Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective
clothing. Note: Nitrile gloves may be worn over polymer laminate gloves to improve dexterity.
Gloves made from the following material(s) are recommended: Polymer laminate
If this product is used in a manner that presents a higher potential for exposure (eg. spraying, high splash potential etc.), then
use of protective coveralls may be necessary. Select and use body protection to prevent contact based on the results of an