SDS
3M™ Plastic and Emblem Adhesive - Clear PN 03601 & 33601 08/03/22
__________________________________________________________________________________________
Page 4 of 15
Hazardous Decomposition or By-Products
Substance
Condition
Carbon monoxide
During Combustion
Carbon dioxide
During Combustion
5.3. Special protective actions for fire-fighters
Water may not effectively extinguish fire; however, it should be used to keep fire-exposed containers and surfaces cool and
prevent explosive rupture. Wear full protective clothing, including helmet, self-contained, positive pressure or pressure
demand breathing apparatus, bunker coat and pants, bands around arms, waist and legs, face mask, and protective covering
for exposed areas of the head.
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Evacuate area. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Use only non-sparking tools.
Ventilate the area with fresh air. For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or
exhaust vapors, in accordance with good industrial hygiene practice. Warning! A motor could be an ignition source and
could cause flammable gases or vapors in the spill area to burn or explode. Refer to other sections of this SDS for
information regarding physical and health hazards, respiratory protection, ventilation, and personal protective equipment.
6.2. Environmental precautions
Avoid release to the environment. For larger spills, cover drains and build dikes to prevent entry into sewer systems or
bodies of water.
6.3. Methods and material for containment and cleaning up
Contain spill. Cover spill area with a fire-extinguishing foam. Working from around the edges of the spill inward, cover
with bentonite, vermiculite, or commercially available inorganic absorbent material. Mix in sufficient absorbent until it
appears dry. Remember, adding an absorbent material does not remove a physical, health, or environmental hazard.
Collect as much of the spilled material as possible using non-sparking tools. Place in a metal container approved for
transportation by appropriate authorities. Clean up residue with an appropriate solvent selected by a qualified and
authorized person. Ventilate the area with fresh air. Read and follow safety precautions on the solvent label and SDS. Seal
the container. Dispose of collected material as soon as possible in accordance with applicable
local/regional/national/international regulations.
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Do not use in a confined area with minimal air exchange. Keep out of reach of children. Do not handle until all safety
precautions have been read and understood. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Use
only non-sparking tools. Take precautionary measures against static discharge. Do not breathe
dust/fume/gas/mist/vapors/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when using this
product. Wash thoroughly after handling. Contaminated work clothing should not be allowed out of the workplace.
Avoid release to the environment. Wash contaminated clothing before reuse. Avoid contact with oxidizing agents (eg.
chlorine, chromic acid etc.) Wear low static or properly grounded shoes. Use personal protective equipment (gloves,
respirators, etc.) as required. To minimize the risk of ignition, determine applicable electrical classifications for the process
using this product and select specific local exhaust ventilation equipment to avoid flammable vapor accumulation.
Ground/bond container and receiving equipment if there is potential for static electricity accumulation during transfer.
7.2. Conditions for safe storage including any incompatibilities
Store in a well-ventilated place. Keep cool. Keep container tightly closed. Store away from heat. Store away from
acids. Store away from oxidizing agents.
SECTION 8: Exposure controls/personal protection