User's Manual

Appendix A
Disposal of the IDentity 5200 Reader
70
IDentity 5200 User Guide
Disposal of the ID entity 5200 Reader
Prior to disposing of the IDentity 5200 Reader, the battery must be
removed. The battery used in the IDentity 5200 is a Lithium / Manganese
Dioxide (Li/MnO2) type. This battery contains no measurable amounts of
mercury, lead, or cadmium.
Caution:
The procedure outlined in this appendix requires opening the IDentity 5200
Reader case in order to remove the battery prior to disposal. Opening the
case of the IDentity 5200 will void the warranty. In addition, opening the case
may adversely affect any future operation of the reader.
Never open the case of the IDentity 5200 Reader unless you are going to
remove the battery and dispose of the unit.
All disposal operations must be performed within local guidelines and laws. It
is the responsibility of the reader owner to ensure all local and regional laws
and regulations are followed for proper reader disposal.
To remove the battery, perform the following:
1 Remove the reader from service and disconnect any power, antenna,
and communication cables.
2 Remove the 12 Philips head screws on the front panel and remove the
panel.
3 If necessary, disconnect the LED wires.
4 Using an SMA connector wrench, remove the cable from the antenna
and set the antenna aside.