User's Manual

1 2 3 4 5
6
7 8 9
Reader Configuration Tool
IDentity 5200 User Guide 53
Change Operating Mode
This page allows you to configure the operational mode of the reader.
The reader supports the following operational modes:
h Active Mode - Reader is continuously attempting to singulate tags and
automatically reports any singulated tag via an asynchronous event
notification on the event channel.
h Stand By Mode - Reader is not transmitting any energy, unless
processing a tag related command. The RF transmitter is enabled at the
beginning of the command processing, any protocol operations required
for the command are performed, and then the RF transmitter is turned
back off.