User's Manual
Table Of Contents
- Preface
- Table of Contents
- Reader Overview
- Reader Equipment Installation
- Reader Startup Tool (RST) Software Installation
- Reader Operation
- Reader Startup Tool (RST)
- Embedded Reader Configuration Tool (RCT)
- Configuring Digital Inputs and Outputs
- Specifications
- Reader Specifications (General)
- Reader Specifications (FCC)
- Environmental Specifications
- Power Supply Specifications
- RS-232 Specifications
- Ethernet LAN Specifications
- Antenna Cable Specifications
- External Antenna Specifications (FCC)
- Bulkhead Connector/Interface Cable Pinout
- Battery Specifications (Optional)
- Safety Instructions
- Disposal of the IDentity 5200 Reader
- Reader Maintenance
1 2 3
4
5 6 7 8 9
Reader Operation
16
IDentity 5200 User Guide
4 From the pull-down menu, select
Reader
→
Login
to login to the
reader. The initial password (
Pwd
) is readeradmin. See the
Advanced Setup section for details on changing the password.
5 From the pull-down menu, verify the
Operating Mode
is set to
Active
.
6 Select the
Tag Performance
tab and press
Start
.
7 Place your tags in front of the antenna and verify the tags are read and
displayed as shown in the following figure.