Datasheet

2
3M Personal Safety Division
3M P5E Earmuff Positions for Use with Industrial Head Protection Products
The following describes acceptable earmuff positions for use and storage. Refer to the user instructions for complete product
information.
Work
Mode: When in use, the attachment arms must be pushed inward until you hear a click on both sides. Make sure the
cups and attachment arms are not in contact with the inner lining or the edge of the hard hat when in the Work Mode,
otherwise this may lead to leakage. Position the earcups over your ears so that the cushions fully enclose the ears and seal
tightly against the head. Adjust the position of each earcup while holding the helmet in place until you have a tight and
comfortable fit that exerts even pressure around the ears.
3M™
G22 E SML SML ML SML L
3M™
G2000 K SML SML SML SML ML
3M™
G3000 (Basic Set) E SML SML SML SML ML
3M™
G3501 E SML SML ML SML L
3M™
H700 E SML L L SML L
Arco Arco Champion H* L L L L L
Arco Arco Champion Plus H* L L L L L
Centurion 1100 (H fitting) H* L L L L L
Centurion 1125 (H fitting) H* L L L L L
Centurion Vulcan H* L L L L L
Petzl Vertex Best, Vent and ST E ML ML ML ML L
C:1 Helmet
manufacture
C:2 Helmet model C:3
Helmet
attachment
C:4 X1P5 C:4 X2P5 C:4 X3P5 C:4 X4P5 C:4
X5P5
3M™
G500 Headgear E SML SML SML SML SML
Compatible Helmets
For Information on ANSI Compliant 3M earmuffs and hard hats please refer to the technical data bulletin entitled:
3M™ PELTOR™ X Series Hard Hat Attached Earmuffs and Industrial Head Protection Compatibility - ANSI Compliant.
Or visit: 3m.com/earmuff_techbulletin