User's Manual
Table Of Contents
- Revision History
- Table of Contents
- Chapter 1. Product Overview
- Chapter 2. Physical Description
- Chapter 3. Installation
- 3.1 Hardware Installation
- 3.2 Software Installation
- 3.2.1 Software Configuration
- 3.2.2 Prepare your PC for DWR Configuration
- 3.2.3 Connect to DWR
- 3.2.4 Management and Configuration on DWR
- 3.2.4.1 Status
- 3.2.4.2 Setup Wizard
- 3.2.4.3 Operation Mode
- 3.2.4.4 Wireless - Basic Settings
- 3.2.4.5 Wireless - Advanced Settings
- 3.2.4.6 Wireless - Access Control
- 3.2.4.7 WDS Settings
- 3.2.4.8 Site Survey
- 3.2.4.9 LAN Interface Setup
- 3.2.4.10 WAN Interface Setup
- 3.2.4.11 Firewall - Port Filtering
- 3.2.4.12 Firewall - IP Filtering
- 3.2.4.13 Firewall - MAC Filtering
- 3.2.4.14 Firewall - Port Forwarding
- 3.2.4.15 Firewall – URL Filtering
- 3.2.4.16 Firewall - DMZ
- 3.2.4.17 Management - Statistics
- 3.2.4.18 Management - DDNS
- 3.2.4.19 Management - Time Zone Setting
- 3.2.4.20 Management – Denial-of-Service
- 3.2.4.21 Management - Log
- 3.2.4.22 Management - Upgrade Firmware
- 3.2.4.23 Management - Save/ Reload Settings
- 3.2.4.24 Management - Password Setup
- 3.2.4.25 Logout
- Appendix A – FCC Caution
http://www.3jtech.com.tw
http://www.pnpipcameras.com
DWR User’s Guide
Copyright of 3JTech Co., Ltd. (also doing business as A3J Engineering Inc.)
27
3.2.4.10 WAN Interface Setup
This page is used to configure the parameters for wide area network that connects to the WAN port
of your DWR. Here you may change the access method to Static IP, DHCP, PPPoE or PPTP by
clicking the item value of WAN Access Type.
Static IP
Fig. 3-15
Item Description
Static IP Click to select Static IP support on WAN interface.
There are IP address, subnet mask and default
gateway settings need to be done.
IP Address If you select the Static IP support on WAN interface,
fill in the IP address for it.
Subnet Mask If you select the Static IP support on WAN interface,
fill in the subnet mask for it.
Default Gateway If you select the Static IP support on WAN interface,
fill in the default gateway for WAN interface out
going data packets.