User's Manual
Table Of Contents
- Revision History
- Table of Contents
- Chapter 1. Product Overview
- Chapter 2. Physical Description
- Chapter 3. Installation
- 3.1 Hardware Installation
- 3.2 Software Installation
- 3.2.1 Software Configuration
- 3.2.2 Prepare your PC for DWR Configuration
- 3.2.3 Connect to DWR
- 3.2.4 Management and Configuration on DWR
- 3.2.4.1 Status
- 3.2.4.2 Setup Wizard
- 3.2.4.3 Operation Mode
- 3.2.4.4 Wireless - Basic Settings
- 3.2.4.5 Wireless - Advanced Settings
- 3.2.4.6 Wireless - Access Control
- 3.2.4.7 WDS Settings
- 3.2.4.8 Site Survey
- 3.2.4.9 LAN Interface Setup
- 3.2.4.10 WAN Interface Setup
- 3.2.4.11 Firewall - Port Filtering
- 3.2.4.12 Firewall - IP Filtering
- 3.2.4.13 Firewall - MAC Filtering
- 3.2.4.14 Firewall - Port Forwarding
- 3.2.4.15 Firewall – URL Filtering
- 3.2.4.16 Firewall - DMZ
- 3.2.4.17 Management - Statistics
- 3.2.4.18 Management - DDNS
- 3.2.4.19 Management - Time Zone Setting
- 3.2.4.20 Management – Denial-of-Service
- 3.2.4.21 Management - Log
- 3.2.4.22 Management - Upgrade Firmware
- 3.2.4.23 Management - Save/ Reload Settings
- 3.2.4.24 Management - Password Setup
- 3.2.4.25 Logout
- Appendix A – FCC Caution
http://www.3jtech.com.tw
http://www.pnpipcameras.com
DWR User’s Guide
Copyright of 3JTech Co., Ltd. (also doing business as A3J Engineering Inc.)
24
Item Description
Enable WDS Click the checkbox to enable wireless distribution
system function.
MAC Address Fill in the MAC address of AP to register the wireless
distribution system access capability.
Comment Fill in the comment tag for the registered AP.
Apply Changes
Click the Apply Changes button to register the AP
to new configuration setting.
Reset
Click the Reset button to abort change and recover
the previous configuration setting.
Set Security Click button to configure wireless security like
WEP(64bits), WEP(128bits), WPA(TKIP),
WPA2(AES) or None
Show Statistics It shows the TX, RX packets, rate statistics
Delete Selected Click to delete the selected clients that will be
removed from the wireless distribution system.
Delete All Click to delete all the registered APs from the
wireless distribution system allowed list.
Reset
Click the Reset button to abort change and recover
the previous configuration setting.
3.2.4.8 Site Survey
This page is used to view or configure other APs near yours.
Fig. 3-13