User's Manual
Table Of Contents
- Revision History
- Table of Contents
- Chapter 1. Product Overview
- Chapter 2. Physical Description
- Chapter 3. Installation
- 3.1 Hardware Installation
- 3.2 Software Installation
- 3.2.1 Software Configuration
- 3.2.2 Prepare your PC for DWR Configuration
- 3.2.3 Connect to DWR
- 3.2.4 Management and Configuration on DWR
- 3.2.4.1 Status
- 3.2.4.2 Setup Wizard
- 3.2.4.3 Operation Mode
- 3.2.4.4 Wireless - Basic Settings
- 3.2.4.5 Wireless - Advanced Settings
- 3.2.4.6 Wireless - Access Control
- 3.2.4.7 WDS Settings
- 3.2.4.8 Site Survey
- 3.2.4.9 LAN Interface Setup
- 3.2.4.10 WAN Interface Setup
- 3.2.4.11 Firewall - Port Filtering
- 3.2.4.12 Firewall - IP Filtering
- 3.2.4.13 Firewall - MAC Filtering
- 3.2.4.14 Firewall - Port Forwarding
- 3.2.4.15 Firewall – URL Filtering
- 3.2.4.16 Firewall - DMZ
- 3.2.4.17 Management - Statistics
- 3.2.4.18 Management - DDNS
- 3.2.4.19 Management - Time Zone Setting
- 3.2.4.20 Management – Denial-of-Service
- 3.2.4.21 Management - Log
- 3.2.4.22 Management - Upgrade Firmware
- 3.2.4.23 Management - Save/ Reload Settings
- 3.2.4.24 Management - Password Setup
- 3.2.4.25 Logout
- Appendix A – FCC Caution
http://www.3jtech.com.tw
http://www.pnpipcameras.com
DWR User’s Guide
Copyright of 3JTech Co., Ltd. (also doing business as A3J Engineering Inc.)
18
3.2.4.3 Operation Mode
This page is used to configure which mode that DWR will act.
Fig. 3-8
Item Description
Gateway Traditional gateway configuration. It always
connects Internet via ADSL/Cable Modem. LAN
interface, WAN interface, Wireless interface, NAT
and Firewall modules are applied to this mode.
Bridge Each interface (LAN, WAN and Wireless) regards as
bridge. NAT, Firewall and all router’s functions are
not supported.
Wireless ISP Switch Wireless interface to WAN port and all
Ethernet ports in bridge mode. Wireless interface
can do all router’s functions.
Apply Changes
Click the Apply Changes button to complete the
new configuration setting.
Reset
Click the Reset button to abort change and recover
the previous configuration setting.