User's Manual

20000505-001 Revision A CM9 Internal Installation Manual
Page 6 of 10 Proprietary & Confidential August, 2005
4. FCC LABEL
The CM9 Module must be labeled with its FCC ID (see Figure F). If the FCC ID label shown in Figure F is
not visible when the module is installed inside another (external) device, the external device must also
display a label referring to the enclosed module. The exterior label can be “Contains Transmitter Module
FCC ID:QVT-WLAN-MP2” or similar wording (see Figure G).
5. ANTENNA INSTALLATION
The high gain antennas must be installed outdoors on rooftops, towers, or poles in compliance
with FCC rules.
3eTI enforces the requirement that its products must have professional installation due
to the technical difficulty level during installation for all products that use standard polarity RF connectors.
This professional installation requirement is written into the User Manual and sales agreement for 3eTI
products. The following text provides an example of the requirement from the 3e-525A-2 Users Manual
(Document 29000154-001 Revision A Page 11).
FCC Regulations require that the 3e-525A-2 be professionally installed by an
installer certified by the National Association of Radio and Telecommunications
Engineers or equivalent institution.
Only the following antenna types can be used:
• Antenna 1: Vendor: NEARSON, Model: 4010 (use on the 2400-2483.5 MHz band only).
ALERT!: The module antennae should be installed and operated with minimum distance of one
(1) meter - 100 cm - between the radiator and all persons.
•
Antenna 2: Vendor: HyperGain, Model: HG5822G (use on the 5725-5826 MHz band only).
ALERT!: The module antennae should be installed and operated with minimum distance of one
(1) meter - 100 cm - between the radiator and all persons.