User's Manual

CM9 Installation Manual ########-### Revision A
PRINTED COPY UNCONTROLLED UNLESS PRINTED ON IVORY PAPER – VERIFY LATEST REVISION ONLINE.
Revision 00.01.00 Proprietary Page 3 of 10
IMPORTANT NOTES
RF APPLICATION
This FCC ID (QVT-WLAN-MP2) for the combination of the CM9 WLAN module and high gain antennas is restricted to the
outdoor application only. It is only used for 3eTI WLAN outdoor equipment application and the module cannot be sold to end-
users or OEM parties directly. It has to always meet the conditions below:
1. The antenna model 4010 or equipment of the module should be installed and operated with a minimum distance of one (1)
meter between the radiator and all persons. The other antenna model HG5822G or equipment of the module should also
be installed and operated with minimum distance of one (1) meter between the radiator and all persons.
2. The directional antennas should be separated from other WLAN directional antennas with the similar frequency at a
minimum distance of one (1) meter. The antennas cannot be pointed to the same direction.
As long as the two conditions above are met, further transmitter testing will not be required. However, 3eTI is still responsible
for testing the 3eTI end product for any additional compliance requirements required with this module installed (e.g., FCC part
15 for digital device emissions test).
FCC ID
In the event that these conditions listed above cannot be met (e.g., use of the 5.8GHZ high gain antennas for indoor application),
then the FCC authorization is no longer considered valid and the FCC ID cannot be used on the final product. In these
circumstances, the 3eTI will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate
FCC authorization.
END PRODUCT LABELING
This transmitter module is authorized only for use in devices where the antenna may be installed such that one (1) meter (refer
to RF Application Note above) may be maintained between the antenna and users (e.g., wireless outdoor access points and
bridges). The final end product must be labeled in a visible area with the following: "Contains FCC ID: QVT-WLAN-MP2".
PROHIBITIONS
The end user SHALL NOT be provided with any instructions on how to remove or install the CM9 device.