User's Guide

3e-531AP Wireless Access Point Chapter 4 Gateway Conguration
42 29000125-001 C
3e-531AP Wireless Access Point Chapter 4: Gateway Conguration
29000125-001 C 43
Using the navigation bar to the left, navigate to the System Congu-
ration — Operating Mode page, select the Gateway Mode radio button,
and click Apply. The 3e-531AP will reboot in gateway mode and reset all
prior settings to factory default state.
You can then proceed to change the management screens as necessary
to recongure the device as a gateway. Conguration in gateway mode
allows you to set rewall parameters. This is the main difference between
the screens you will see in gateway mode and those covered in access
point setup as discussed in Chapter 3.
Note that you can't deploy the 3e-531AP as a bridge in Gateway
mode, nor is it FIPS 140-2 compliant.
The following sections cover the functions and screens in gateway
mode. Much of the infomation is similar to the access point mode but is
presented here for your convenience.