User's Guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Hardware Installation
- Chapter 3: Access Point Configuration
- Chapter 4: Gateway Configuration
- Chapter 5: Bridge Configuration
- Chapter 6: PC Card Installation on a Laptop
- Chapter 7: The RF Manager Function
- Chapter 8: Network Printer Setup
- Chapter 9: Technical Support
3e-531AP Wireless Access Point Chapter 3: Access Point Conguration
26 29000125-001 C
3e-531AP Wireless Access Point Chapter 3: Access Point Conguration
29000125-001 C 27
Services Settings
DHCP Server
This page allows conguration of the DHCP server function accessible
from the Local LAN port. The default factory setting for the DHCP server
function is enabled. You can disable the DHCP server function, if you
wish. You can also set the range of addresses to be assigned.
Print Server
The print server function can be enabled or disabled. It is enabled by
default. If you do not plan to set up the print server function, you can
click disable and leave the metal plate on the printer port. The metal plate
is provided to protect that port from water.