User Manual
3e-528 Wireless Video Server Chapter 3: Access Point Conguration
42 29000142-001 A
3e-528 Wireless Video Server Chapter 3: Access Point Conguration
29000142-001 A 43
Wireless Clients
The Wireless Clients report screen displays the MAC Address of all wire-
less clients and their signal strength and transmit rate. The screen shown here
emulates the FIPS 140-2 setup and contains a column for EMCON response. This
column is not displayed in non-FIPS mode. The EMCON feature is only works
with the 3e-010F Crypto Client in FIPS mode.
If Transmit power is disabled, either by setting TX Pwr Mode to Off on the
management screen or by using the RF Manager (Chapter 7), the Wireless Clients
screen will show the results from each associated client in the EMCON Response
column. If the client responds to the "disable" command, a Yes is displayed. If
the column contains a No, this can mean either:
• the client didn't receive the command, or
• the client is no longer in the areas, or
• the client software doesn't support the RF management feature.
This status information remains active for 5 minutes after the clients are
disabled.