User Manual

3e-528 Wireless Video Server Chapter 5: Bridge Conguration
68 29000142-001 A
3e-528 Wireless Video Server Chapter 5: Bridge Conguration
29000142-001 A 69
Point-to-Point Bridging Setup Guide
Direction Bridge 1 Bridge 2
Wireless Conguration – Bridging
Wireless Mode
802.11b/g Mixed 802.11b/g Mixed
Tx Rate
AUTO AUTO
Channel No
11 (must be the same as
Bridge 2)
11 (must be the same as
Bridge 1)
Tx Power
Auto Auto
Spanning Tree Protocol
Enable (or Disable if no
bridging loop possible)
Enable (or Disable if no
bridging loop possible)
Bridge signal strength LED port
Enter from list at the
bottom of the screen
Enter from list at the
bottom of the screen
BSSID
Add Bridge 2 MAC Add Bridge 1 MAC
Wireless Conguration – Bridging Encryption
Wireless Conguration – Bridging
Encryption
Select appropriate key
type/length and value.
Must be the same key
as Bridge 2.
Select appropriate key
type/length and value.
Must be the same key as
Bridge 1.
The following sequence walks you through the setup of bridge 1.
Bridge 2 would duplicate this procedure, with the BSSID of bridge 2 be-
ing the MAC address of bridge 1 and vice versa.
First, navigate to the Wireless Conguration — General screen and
select a channel number that does not conict with the AP channel num-
ber. Leave the TX Pwr Mode in AUTO position at this time. If there is a
wireless LAN on the AP WLAN card, information would be set as dis-
cussed in Chapter 3.