User Manual

3e-528 Wireless Video Server Chapter 3: Access Point Conguration
24 29000142-001 A
3e-528 Wireless Video Server Chapter 3: Access Point Conguration
29000142-001 A 25
LAN
This sets up the default numbers for the four octets for a possible private
LAN function for the access point. It also allows changing the default numbers
for the LAN Subnet Mask and the link speed. The Local LAN port provides local
access for conguration. It is not advisable to change the private LAN address
while doing the initial setup as you are connected to that LAN.
Operating Mode
This screen allows you to set the operating mode to either FIPS enabled or
disabled. You can also set the device to use IPv6.
Note that if you change modes, all previously entered information will be
reset to factory settings.
Submodes
There are two options under Submodes:
FIPS 140-2 Mode
Use IPv6 Mode
If you can select the Use IPv6 Mode, the AP will be congured to support
IPv6 addresses on the WAN and LAN ports. In IPv6 mode, the AP can be man-
aged and pass trafc using IPv6 addresses. Since IPv6 is relatively new in the