User's Manual

3e–527A3 Wireless Access Point – 8 Port Chapter 4: Gateway Conguration
70 29000152-001 B
3e–527A3 Wireless Access Point – 8 Port Chapter 4: Gateway Conguration
29000152-001 B 71
Conguring in Gateway Mode
To congure the 3e–527A3 in gateway mode, complete the following
steps.
1. Login on to the 3e–527A3 (see Chapter 3, page 21).
2. Using the navigation bar to the left, navigate to the System Con-
guration — Operating Mode screen, select the Gateway Mode
radio button, and click Apply. The 3e–527A3 AP will reboot in
gateway mode.
Note that if you change modes from AP to Gateway, your congura-
tion is not lost.
You can then proceed to change the management screens as necessary
to recongure the device as a gateway. Conguration in gateway mode
allows you to set rewall parameters. This is the main difference between
the screens you will see in gateway mode and those covered in access
point setup as discussed in Chapter 3.
The following sections only cover the functions and screens that are
unique to the gateway mode. All of the screens that are common to both
the AP and Gateway modes are covered in Chapter 3.