User Manual

55
To use the recorded Cable Cam shot, fly Solo to any location within the blue circle. At this point, or if Solo was
already close enough to the saved shot’s starting point, you see a screen like this:
Figure 6.4.6.2: App - Prompt to load saved Cable Cam sequence
To use the saved shot, tap Load Cable. Alternatively, you can designate the saved shot as a “favorite” by tapping
the heart-shaped icon (1) in the upper right, or delete it by tapping the trash-can icon (2). Any saved shots you
“favorite” in this way subsequently appear in the Favorites listing on the main Saved Shots screen.
After you tap Load Cable, the app loads the saved-shot data and flies Solo to the starting point of the path. At this
point you can run the saved shot the same way as any other Cable Cam shot.
6.5 Orbit
Use Orbit to fly Solo along a preset circle while fixing the camera on a central target.
Note: Orbit uses the Solo App’s mapping feature. For best results, use Orbit with a mobile device that has a live
mobile data link. Alternatively, if using an Android device, you can use a cached map. For details, see Section 6.1.2,
Map View, on page 39.
6.5.1 Starting Orbit
Select Orbit from the Shot List. The App switches to the map screen and shows the location Solo as well as the
direction it’s facing on the map. This screen also shows the orbit center point as a small bullseye, as well as a line
connecting the two points. To change the location of the center point, drag the map image in the App until the
desired center point is at its center.
When the setup is satisfactory, press A on the controller to save the current center point. Once you set the center
point, the App displays a Orbit Center Point Saved confirmation. To adjust the position of the center point during
Orbit, drag the map.