User Manual

50
6.4 Cable Cam
Cable Cam creates a smooth shot by flying Solo automatically along a virtual cable between any number of
waypoints that you specify initially. Basically, after starting the shot, you fly Solo to each successive waypoint in
turn, press A on the controller, and so on. To save the last waypoint, press B, after which you can start Solo flying
along its virtual cable.
6.4.1 Starting Cable Cam
To start Cable Cam, press A on the controller, or select Cable Cam from the Shot List in the App. You’re then
prompted to fly Solo to the start point and save it as the first Cable Cam point by pressing A. You can press A either
on the Controller or on the App screen. Then fly to your next point and save it by pressing A again. Continue moving
to new locations, pressing A at each point to save a waypoint. To finish recording waypoints, press B; this sets a
final waypoint at the current location and switches to a mode where you can fly along the recorded cable.
Tip: While you’re recording waypoints, for an impressive cinematic effect, try varying the altitude or orientation
between successive points. Also, if you have the Solo 3-Axis Gimbal, try changing the view angle between the
endpoints.
Figure 6.4.1.1: App - Cable Cam Setup
Note: Each Cable Cam waypoint must be at a different location than the one before it. If you try to set a second
waypoint at the same position as the previous one, the new waypoint overwrites the previous one and you’re
prompted for another point.