Operation Manual

UP Plus
3D Printer User Manual
6.8.b
The platform rests of three screws just like a tripod. In can be quite misleading looking at a square
surface while having to level a triangle (tripod)
triangular shape.
1.
Remove clips and Perfboard fr
platform.
2.
Click “3D Print” / “Maintenance”
3.
Enter 135 in the To: box and click “To:”
4. Click “Center”
and then move the platform
closer to the nozzle by increasing the “To:”
value.
5.
Once the nozzle is just about 0.2mm away
from the platform, then click “NR” = Near
Right.
6.
Look at the distance between the nozzle
and make a rough mental note, then click
“FR” = Far Right
7.
Look at the distance between the nozzle
and make a rough mental note, then click
“FL” = Far Left
8.
Look at the distance between the nozzle
and make a rough
mental note, then click
“NL” = Near Left
4.
Troubleshooting
3D Printer User Manual
v 2013.6.10
The platform rests of three screws just like a tripod. In can be quite misleading looking at a square
surface while having to level a triangle (tripod)
shape
. It is easier if you imagine you are leveling a
Remove clips and Perfboard fr
om the
It is harder to level the platform with the
Perfboard attached.
Click “3D Print” / “Maintenance”
Enter 135 in the To: box and click “To:”
and then move the platform
closer to the nozzle by increasing the “To:”
Once the nozzle is just about 0.2mm away
from the platform, then click “NR” = Near
The nozzle will move to the N
ear
Look at the distance between the nozzle
and make a rough mental note, then click
The nozzle will move to the
Far
Look at the distance between the nozzle
and make a rough mental note, then click
The nozzle will move to the Far
Look at the distance between the nozzle
mental note, then click
The nozzle will move to the
Near
Troubleshooting
The platform rests of three screws just like a tripod. In can be quite misleading looking at a square
. It is easier if you imagine you are leveling a
It is harder to level the platform with the
ear
Right hand side.
Far
Right hand side.
The nozzle will move to the Far
left hand side.
Near
left hand side.