Operation Manual

UP Plus
3D Printer User Manual
4.2
Calculating model costs
The main factor that will affect
for example, one is printing a cube measuring 30mm x 30mm x 30mm, with a layer thickness of
0.25
mm, the following quantities of material are used depending on the print mode.
Model info: 30×30×30mm layer thickness: 0.2
$1.32 72cents
The easiest way to calculate how much material will be used for your model is to use the “Print
Preview” option under the “3D Print” menu. This will tell you the total weight of material used,
including the raft and any suppo
The price as 6/10
/12 for ABS plastic from
working out to be 0.06
cents per gram.
5. Model
Removal
When the model ha
s finished
heating.
Open the door, remove the clips and s
Slide
the spatula under the model and slowly wiggle it back and forth to pry loose the model.
TIP: Remember to u
se gloves
gloves must be worn.
4.
Troubleshooting
3D Printer User Manual
v 2013.6.10
Calculating model costs
The main factor that will affect
model cost is the honeycomb fill structure
and support material. If,
for example, one is printing a cube measuring 30mm x 30mm x 30mm, with a layer thickness of
mm, the following quantities of material are used depending on the print mode.
Model info: 30×30×30mm layer thickness: 0.2
5mm
56cents 51cents
The easiest way to calculate how much material will be used for your model is to use the “Print
Preview” option under the “3D Print” menu. This will tell you the total weight of material used,
including the raft and any suppo
rt material.
/12 for ABS plastic from
www.3DPrintingSystems.com
was AU$59 per 1KG
cents per gram.
Removal
s finished
printing, the printer will beep, and the
nozzle and platform stop
Open the door, remove the clips and s
lide the Perfboard out from the
printer platform
the spatula under the model and slowly wiggle it back and forth to pry loose the model.
se gloves
as the platform and model may still be hot.
The spatula is sharp,
Troubleshooting
and support material. If,
for example, one is printing a cube measuring 30mm x 30mm x 30mm, with a layer thickness of
mm, the following quantities of material are used depending on the print mode.
The easiest way to calculate how much material will be used for your model is to use the “Print
Preview” option under the “3D Print” menu. This will tell you the total weight of material used,
was AU$59 per 1KG
nozzle and platform stop
printer platform
.
the spatula under the model and slowly wiggle it back and forth to pry loose the model.
The spatula is sharp,