Operation Manual

UP Plus
3D Printer User Manual
3. Operation
3.1 Preparation
3.1.1
Quick Setup
1. Remove the two
packing clips that hold the extruder head
and platform
in place during shipping.
2. Attach the “
roll holder
of the printer
using the middle sized included alan key.
Remove screw (b) and attach the roll holder as per
diagram and attach with screw (b)
3.
Open the foil bag that contains
4.
Troubleshooting
3D Printer User Manual
v 2013.6.10
Quick Setup
packing clips that hold the extruder head
in place during shipping.
roll holder
/ feeder guide” onto the left side
using the middle sized included alan key.
Remove screw (b) and attach the roll holder as per
diagram and attach with screw (b)
Open the foil bag that contains
the ABS filament.
NOTE:
Do not let go of the end of the filament,
otherwise it will
unravel
which will then cause a block in the extruder head and
several hours of unwinding the spool manually to find
the knot!
Troubleshooting
Do not let go of the end of the filament,
unravel
itself and tie itself in a knot,
which will then cause a block in the extruder head and
several hours of unwinding the spool manually to find