Information

Click FAST button once. When
Plastic starts extruding, push
Nozzle down into paper to get
Plastic to stick to surface.
Try writing your name. While
Plastic is extruding, push Nozzle
down. Drag Plastic along the
paper or surface in a continuous
unbroken line, as if you were
writing with a pencil.
Keep your movement slow and
steady. Plastic should hold to
the surface and not curl up
around the Nozzle.
When you reach the end of your
name, stop extruding by clicking
the FAST button once again. Wait
a moment before removing pen
then simply peel o your doodle!
1.
2.
3.
4.
HOW TO DOODLE
ON A FLAT
SURFACE
SNIP THOSE ENDS!
Keep it clean. Snip your ends to avoid
any unnecessary jams in your 3Doodler.
For optimal Doodling use these
temperature settings for your Plastic:
PICK YOUR PLASTIC
When switching from a HI temp Plastic
(ABS or FLEXY) to a LO temp Plastic (PLA),
run Pen on ABS/FLEXY setting until HI
temp Plastic is fully extruded (you’ll see
the Plastic color change!). Then switch
Pen to the PLA temp setting.
BEFORE
SWITCHING FROM
ABS/FLX TO PLA
CHANGING PLASTIC
ABS
FLEXY
PLA
Setting: ABS/FLEXY
Light: Blue
How to tell: Plastic has
white semi-circle ends.
Setting: ABS/FLEXY
Light: Blue
How to tell: Plastic is
exible.
Setting: PLA
Light: Green
How to tell: Very rigid
when bent, no white
semi-circles
17 18