User's Manual

Button
Commands, macros or radial menus can be assigned to 3D mouse buttons through the button panel in the
properties of 3Dconnexion. The active application is displayed at the top left of the panel, and the changes made
are only applied to that application. This allows you to independently configure the 3D mouse for each
application.
Switch
The purpose of the power switch of this product is to turn the product on or off. Green is the on state of the
product, and red is the off state.
I/O port
Use USB cable to connect to the I/O port on the product, and then connect to the power supply to charge the
product. Navigating the 3D world can now start the 3Dconnexion navigation experience. It is recommended that
you start by running our demo applications, which can be launched from the 3Dconnexion Home.
Guidance on safety and efficient use
1. Input: 5V , 500mA
2. Do not disassemble the product unless it is necessary to dispose of the end-of-life product.
3. Do not allow the product to come into liquid or be exposed to a humid environment.
4. Do not operate the product when the temperature exceeds the specified operating temperature range
(0°C to 40°C).
Battery warning
The battery used in wireless products are non-user-serviceable. Please do not attempt to change the battery
yourself. Instead, contact 3Dconnexion Technical Support for repair or replacement information.
Risk of explosion or personal injury if batteries are exposed to conducting materials, liquid, fire, or heat.
Wireless product
Hereby, 3Dconnexion declares that the radio-frequency products are compliance to the essential requirements
and relevant provision of CE (RED 2014/53/EU) and FCC (Part 15B, 15C). The Declaration of Conformity can
be retrieved from www.3dconnexion.com/compliance.
Supported Operation Systems
Use USB cable to connect to the I/O port on the product, and then connect to the power supply to charge the
product. Navigating the 3D world can now start the 3Dconnexion navigation experience. It is recommended that
you start by running our demo applications, which can be launched from the 3Dconnexion Home.
3Dconnexion Universal Receiver 2.4GHz Bluetooth 4..0 Low Enger / Smart
Windows 10, Windows 8.1, Windows 8, Windows 7
MacOS 10.10 or later
Windows 10, Windows 8.1, Windows 8
MacOS 10.10 or later
For further detailed information about the equipment, please visit our website www.3dconnexion.com.
Compliance
The products are compliant to the following and some other regional compliance marks:
Changes or modifications not expressly approved by the responsible party for compliance could void the user’s
authority to operate the equipment. Please visit www.3dconnexion.com/compliance for additional compliance
information.