Manualshelf

Certifications 2

ManualsBrands3D Xtech Manuals3D Printer Filaments3DXSTAT Conductive ESD Filament PETG 1.75 mm 1000 g Black 1 pc(s)
123
2
6 ACCIDENTAL RELEASE MEASURES
Spill or release: Clean up by vacuuming or sweeping to prevent falls. If molten, allow material to cool and place into an
appropriate container for disposal.
7 HANDLING AND STORAGE CONDITIONS
Precautions to be taken in handling and storage: Store in a dry, sprinkler equipped warehouse. Product as shipped is
not a combustible dust. Mechanical handling can cause the formation of dusts. To reduce the risk for dust explosion
do not permit dust to accumulate.
Waste Disposal: Dispose in accordance with applicable federal, state and local regulations.
8 EXPOSURE AND PROTECTION INFORMATION
Exposure Limits: This product does not contain any hazardous materials with occupational exposure limits established
by the region specific regulatory bodies.
Respitory Protection: A NIOSH approved respirator is recommended for protection against processing polymeric
fumes, or from dust generated from grinding, sanding, or sawing operations.
Ventilation: Local exhaust is preferred.
Protection Gloves: : Canvas or cotton gloves are recommended.
Eye Protection: Safety glasses with side shields are recommended.
Other: No protective equipment is needed under normal use conditions.
9 PHYSICAL/CHEMICAL DATA
Form: Solid
Appearance: Black Filament
Odor: None
Freezing Point: N/A
Solubility in Water: Insoluble
Specific Gravity: >1
% Volatile: N/A
Boiling Range: N/A
Vapor Pressure (MM HG): Negligible
Melting Point: This product does not possess a specific melting point. It softens gradually over a wide temperature
range.
Note: Those physical data are typical values based on material tested but may vary from sample to sample. Typical
values should not be construed as a guaranteed analysis of any specific lot or as specifications for the product.
10 STABILITY AND REACTIVITY
Polymerization conditions to avoid: None
Chemical Stability: Stable under normal conditions
Conditions to avoid: Incompatible materials, including strong oxidizing agents
Hazardous decomposition byproducts: Thermal decomposition can yield intense heat, dense smoke, phenols, hydrogen
cyanide, carbon dioxide, and carbon monoxide.
11 TOXICOLOGICAL INFORMATION
No specific toxicological information is available.
12 ECOLOGICAL INFORMATION
No specific ecological information is available.