Data Sheet

63D Systems, Inc.
3
SENSE SCANNER SETUP
Unpack and set up your scanner and scanner software before you get started with the basics of scanning.
WHAT'S INCLUDED
The box contains the Sense 3D scanner with attached USB cable and the Quick Start Guide.
Remove the scanner from the box and plug the USB cable into your computer.
DOWNLOAD THE SENSE SOFTWARE
Navigate to http://www.3dsystems.com/shop/sense/downloads, and follow the instructions to complete the software download and
installation.
RUN THE SENSE SOFTWARE
When you installed the Sense software, a shortcut was created on your desktop. Use the shortcut to open the application.
NOTE: If the scanner is not connected to your computer, a message will state "Device not connected." Plug the USB
connector for the scanner into the USB port on your computer.
You will then be prompted to activate your Sense 3D scanner.
ACTIVATE YOUR SENSE SCANNER
If you do not have an activation code, click on Get activation code. Once you have your activation code, you can enter it into the
activation dialog box. Click Activate scanner to complete the activation.