Safety data sheet

Safety Data Sheet
according to Regulation (EC) No 1907/2006 (REACH),
GHS Rev 04 (2011): US, OSHA, CMA, ANSI
WHS Regulations Australia,
JIS Z 7253 (2012): Japan
CubePro
®
Nylon filament
Revision Date: 30 October 2014
________________________________________________________________________________________
SDS GHS • Cube Nylon • 403219-S12-00-A • ENGLISH 4
13. DISPOSAL CONSIDERATIONS
13.1 Appropriate disposal / Product: Do not dump into any sewers, on the ground, or into any body of water.
All disposal methods must be in compliance with all Federal, State/Provincial and local laws and regulations.
Regulations may vary in different locations. Waste characterizations and compliance with appliance laws are the
responsibility solely of the waste generator.
For unused & uncontaminated product, the preferred options include sending to a licensed, permitted recycler,
reclaim, incinerator or other thermal destruction device.
13.2 Waste codes / waste designations according to EWC / AVV:
____________________________________________________________________________________
14. TRANSPORT INFORMATION
14.1 Land transport (ADR/RID/GGVSE): Not regulated
14.2 Sea transport (IMDG-Code/GGVSee): Not regulated
14.3 Air transport (ICAO-IATA/DGR): Not regulated
________________________________________________________________________________
15. REGULATORY INFORMATION
15.1 EU regulations
EINEC/ELINCS/NLP: All materials are listed
REACH Annex XVII: None listed
15.2. US FEDERAL
TSCA: All materials are listed on the TSCA Inventory or are not subject to TSCA requirements:
California Proposition 65: This product does not contain chemicals which are known to the state of California to
cause cancer, birth, or any other reproductive defects.
__________________________________________________________________________________
16. OTHER INFORMATION
SDS Creation Date: .......October 30, 2014
SDS Revision #: .............NA
SDS Revision Date: .......NA
Reason for Revision: ......NA
www.3dsystems.com
800.793.3669 (Toll-free in the US GMT-07:00; N. America, Mon – Fri, 6:00 a.m. to 6 p.m.)
803.326.3900 (Outside the U.S. GMT-07:00; N. America, Mon – Fri, 6:00 a.m. to 6 p.m.)
[phone] (Europe GMT+01:00; Mon – Fri, 08:00 a.m. - 17:00 p.m. MEZ)
DISCLAIMER OF LIABILITY: The following supersedes any related provision in your company’s forms, letters, and agreements
from, by or with 3D Systems Corporation. 3D Systems Corporation makes no warranty, whether expressed or implied, including
warranties of merchantability or of fitness for a particular purpose for this product. No statements or recommendations contained in
the product literature are to be construed as inducements to infringe any relevant patent now or hereafter in existence. Under no
circumstances shall 3D Systems Corporation be liable for incidental, consequential, special, or other damages from alleged
negligence, breach of warranty, strict liability or any other theory, arising out of the manufacture, use, sale, or handling of this
product. In no event shall the liability of 3D Systems Corporation for any claims arising out of the manufacture, use, handling, or
sale of its products exceed an amount equal to the buyer’s purchase price.
The contents of this safety data sheet are subject to change without notice. 3D Systems, Inc. recommends that you periodically
check www.3dsystems.com to make sure you are using the most current safety data sheet.
© Copyright 2014 by 3D Systems, Inc. All rights reserved. The 3D logo and Cube are registered trademarks of 3D Systems, Inc.