Safety data sheet

Safety Data Sheet
according to Regulation (EC) No 1907/2006 (REACH),
GHS Rev 04 (2011): US, OSHA, CMA, ANSI
WHS Regulations Australia,
JIS Z 7253 (2012): Japan
CubePro
®
Nylon filament
Revision Date: 30 October 2014
________________________________________________________________________________________
SDS GHS • Cube Nylon • 403219-S12-00-A • ENGLISH 2
5. FIRE-FIGHTING MEASURES
5.1. Suitable extinguishing media: Water mist, dry chemical, carbon dioxide, or appropriate foam.
5.2 Extinguishing media which must not be used for safety reasons: -
5.3 Special exposure hazards arising from the substance or preparation itself, combustion products,
resulting gases: During a fire, combustion products including but not limited to carbon monoxide, carbon dioxide,
ammonia, aliphatic amines, ketones, nitriles and hydrogen cyanide may be emitted.
5.4 Special protective equipment for fire-fighters: Use self-contained breathing apparatus. Use water spray to
keep fire-exposed containers cool. Dust is not expected to be generated in the event of a fire.
________________________________________________________________________________
6. ACCIDENTAL RELEASE MEASURES
6.1. Personal precautions: Wear appropriate protective equipment and clothing.
6.2 Environmental precautions: Keep out of irrigation ditches, sewers and water supplies.
6.3 Methods for cleaning up: Sweep up and dispose of properly.
________________________________________________________________________________
7. HANDLING AND STORAGE
7.1 Handling: Avoid contact with skin and eyes. Do not allow to enter drains or watercourses.
7.2 Storage: Store sealed in the original container at room temperature.
_____________________________________________________________________________________
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Although some of the additives used in this product may have exposure guidelines, these additives are encapsulated
in the product and no exposure would be expected under normal handling conditions.
8.1 Exposure limit values:
No occupational exposure limits (PEL/TWA) have been established for this product.
8.2 Exposure controls:
Technical measures to prevent exposure: Good general ventilation should be sufficient for normal operation.
Personal protection equipment: If product is used as intended, no personal protective equipment is required.
Respiratory protection: NA
Eye protection: NA
Body protection: NA
_____________________________________________________________________________________
9. PHYSICAL AND CHEMICAL PROPERTIES
9.1 Appearance:
Physical state: Solid filament
Colour: White, black, natural
Odour: Odourless