Cube 3 User Guide

213D Systems, Inc.
NOTE: If Auto Gap is not successful, it is recommended that you
perform Auto Level and Auto Gap again. Select AUTO LEVEL to
continue.
NOTE: If Auto Gap is not successful the second time, select PLATE
MAINTENANCE. For more information, refer to the section titled
Print Pad Maintenance. Once the Plate Maintenance procedure has
been performed, perform Auto Level and Auto Gap.
NOTE: If Auto Gap is still not successful, select MANUAL GAP
ADJUSTMENT. Refer to the section titled Manual Gap Adjustment for
more information. Once the Manual Gap Adjustment procedure has
been performed, note the nal reading for future reference.
4. Select PRINT.
NOTE: The printer will continue the process of printing the welcome
message test print. Select SKIP to bypass this test print. You can
print this test print at any time. Navigate to the System 1 screen and
select TEST PRINT. Follow the prompts in the touchscreen display.
NOTE: If the color built into the test print does not match a color
of one of the installed print cartridges, the printer will assign an
installed cartridge color to the test print. Select the checkmark to
continue.
5. Gently squeeze the bottle and apply two thin layers of Cube Glue to the print
pad. Select the checkmark to continue.
NOTE: For more information about applying glue to the print pad,
refer to the section titled Applying Cube Glue.
NOTE: Apply enough glue to cover a square area of 5” (15 cm).
NOTE: For best results, allow the glue to dry prior to printing.
NOTE: The printer will begin to heat and then begin printing the
welcome message test print.