Cube 3 User Guide

203D Systems, Inc.
NOTE: When prompted, tighten the lock screw enough to ensure
the adjustment knob does not easily turn. Select the checkmark to
perform Auto Level again.
Caution: Do not over-tighten the lock screw. This can damage the
adjustment knob and void the manufacturer’s warranty.
4. Select the checkmark to continue.
5. Install the print pad and select the checkmark to perform Auto Gap.
NOTE: To install the print pad, place it on top of the adjustment
knobs. When the print pad is centered properly, magnets will secure
the print pad to the adjustment knobs.
NOTE: The printer will perform an automated gap measurement.
6. Select the checkmark to continue.
NOTE: The value presented on the touchscreen display is the
absolute print pad position. Note and refer to this value when
performing the Manual Level procedure. Your number may differ
from the illustration.