Cube 3 Quick Start Guide

MANUAL GAP ADJUSTMENT

If Auto Gap is unsuccessful, you may perform a manual gap adjustment to ensure the rst layer of the

part prints properly.

1. Select MANUAL GAP ADJUSTMENT.

2. Place the gap gauge on top of the print pad under the left

print jet. Select the checkmark to continue.

NOTE: Ensure the left cartridge is installed

before performing this procedure.

NOTE: The Gap Gauge is a thin polyester strip

approximately 8.5” (216 mm) long and 1.5” (38

mm) wide.

3. Gently slide the gap gauge back and forth between the

print pad and the left print jet. Using the arrows, raise or

lower the print pad until you feel a slight resistance on the

gauge. Select the checkmark when you feel the proper

resistance.

Caution: Exercise caution to prevent the print jet

from pressing into the print pad. Once you feel

a slight resistance in the Gap Gauge as it moves

between the print pad and the left print jet, the

gap is correct.