Cube 3 Quick Start Guide

MAINTENANCE

PRINT PAD MAINTENANCE

Auto Level and Auto Gap can be affected by a residual glue or print material adhered to the print pad.

These procedures can also be affected by a print pad that is too shiny. Remove all glue and print

material from the print pad before performing Print Pad Maintenance.

1. Select PLATE MAINTENANCE.

2. Remove the print pad. Lift up the front of the print pad and

pull it out of the printer.

NOTE: The print pad is magnetically attached to

the adjustment knobs.

3. Using the included ne-grit sandpaper, lightly buff the print

pad.

NOTE: Refer to the section titled Clean The Print

Pad for specic instructions.

NOTE: Ensure the print pad is clean and dry

before installing it in the printer.

4. Select the checkmark to continue.

5. Perform the Auto Level and Auto Gap procedures.