Cube 3 User Guide

293D Systems, Inc.
NOTE: If the print le requires PLA material and ABS material is
installed, the printer will prompt you to change the cartridge(s).
Select CHANGE CARTRIDGE and refer to the section titled Replacing
A Material Cartridge for instructions about replacing a cartridge.
NOTE: If the print le requires ABS material and PLA material is
installed, the printer will prompt you to change the cartridge(s).
Select CHANGE CARTRIDGE and refer to the section titled Replacing
A Material Cartridge for instructions about replacing a cartridge.
NOTE: If there is not enough material to complete the print but you
want to use up the remaining material, select the checkmark to
continue printing.
NOTE: If the le was built with color(s) that are not installed, the
printer will assign a color from one of the installed cartridges that
match the material type. Select the checkmark to continue.
4. Apply two thin layers of Cube Glue to the center of the print pad. Select the
checkmark to continue.
NOTE: Ensure that the area where glue is applied is larger than the
dimensions of the base of your creation.
NOTE: For best results, allow the glue to dry before printing.