Cube 3 User Guide

193D Systems, Inc.

NOTE: The printer will begin the Auto Level procedure. This may

take a few minutes.

NOTE: If the print pad is not level, remove the print pad and select

the checkmark to continue. The print pad is magnetically attached to

the adjustment knobs. To remove it, lift up the front of the print pad

and pull it out of the printer.

NOTE: Follow the instructions on the touchscreen display. Use the

included 1.5 mm Allen wrench to loosen the lock screws securing

the adjustment knobs to the bracket before turning the knobs. Select

the checkmark to continue.

NOTE: The lock screw (1) is located just below the adjustment knob

(2). The lock screw for adjustment knob B can be accessed from the

front of the printer. The lock screw for adjustment knob A can be

accessed from behind the printer.

NOTE: Follow the instructions on the touchscreen display. Once the

adjustments have been made, select the checkmark to continue.