User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
683D Systems, Inc.
Offset Jets Calibration Procedure
The following procedure demonstrates calibrating print jets 1 and 2 on the X-axis. Calibrating the Y-axis is the same procedure. The
illustration below will be used for demonstration purposes. Be sure to refer to the actual scale printed by your printer and adjust the
settings accordingly.
1. Browse to http://cubify.com/en/CubePro/Activate.
2. Select CALIBRATION FILES.
NOTE: The les will begin to download.
3. Extract the les to your computer’s hard drive.
4. Navigate to the le location and copy the appropriate Nozzle Offset Calibration le to your USB mass storage device.
NOTE: The Nozzle Offset Calibration les are specic for the model printer (CubePro Duo or CubePro Trio) and
for the material type (ABS or PLA) currently installed in the printer.