User's Guide

Required Antenna Separation

The FCC/IC wireless approval for this product is conditional on maintaining at least 20cm

separation between the antennas of all radio transceivers

. There is no restriction for the

separation between the antennas from the same transceiver, but installation testing is

recommended to verify the system performance that is achieved with a specific antenna

deployment. Osprey transceivers are denoted by the combination of the frequency band and

technology. For example, a Rajant 2.4 GHz antenna, Rajant 5 GHz antenna, and an LTE antenna

all use different transceivers.

All antennas should be connected with 50 ohm coaxial cable. Low loss LMR400 ultra-flex cable,

or better, is recommended for all installations.

Warning: To satisfy FCC RF exposure requirements a minimum safe distance of 35 cm must be

maintained between this device and all persons while the device is operating.

Caution: To reduce potential radio interference to other users, the antenna type and its gain

should be chosen so that the Equivalent Isotropically Radiated Power (EIRP) is not more than that

permitted for successful communication.

Caution: For all antenna separation concerns, on-bench or once installed, please contact 3D-P

Support.

This includes any external antennas that are in proximity to the Osprey radio system.