User Manual

Table Of Contents
page 22
... print your plane | www.3DLabPrint.com
Shopping list
Printing material: 0,65kg of PLA (150g of LW-PLA)
RC: 4 channel receiver for your RC system
Motor: any motor for 3S - 6S Li-Pol with weight up to 100g
EMAX MT 3510 600KV (for 6S setup)
DYS D4215 650KV (for 6S setup)
AX-4008Q 620KV (for 6S setup, motor is discontinued
- use it from your old planes)
Leopard LC2830 980KV (for 3S setup)
Controller: Speed controller (ESC) YEP 40A/6S
CastleCreation Talon 25A / 6S
or similar
Battery: 6S Battery LiPol 1300-1800mAh/6s
Servos: 3x Hitec HS-82MG or Corona CS-238MG
or any medium sized servos
30x12x30mm (1.17 x 0.47 x 1.16 inches)
2x servo extension cables 300mm / 12 inch
Glue: CA Glue - medium viscosity
Activator for CA Glue
Other: 1x 1 - 1,2 mm / 14 AWG pushrod wire or carbon rod
1x 0,8 mm pushrod wire
2x M5 fitting screws and nuts or rubber bands for wings
4x M3 screws and nuts