User Manual

page 18
... print your plane | www.3DLabPrint.com
6. Servo installation
Extend the servo leads and install the prepared servos to wing servo bays. Use a 1mm steel
wire with Z bends as a linkage between the servos and aileron control horns. Glue servo co-
vers to the wing. Elevator servo will be fixed by servo holder in the fuselage.
See video guide #6
you will need: 3x Hitec HS-82MG or Corona CS-238MG
or any similar sized servos
30x12x30mm (1.17 x 0.47 x 1.16 inches)
2x 300mm servo extension
Snap knife, Z pliers
7. Motor & ESC & battery holder
Fix the battery using zipper ties to the battery holder and mount it in the front of the fuselage,
find the perfect balance and CG position by moving it. Mount the motor on an alluminium
cross using 4x M3 screws and nuts to the printed universal holder. You can also use the
printed holder 16 x 19 mm from PET or anealed PLA. Glue universal motor mount with motor
into the fuselage in right position.
See video guide #7
you will need:
4x M3 screws and nuts