User Manual

page 17
... print your plane | www.3DLabPrint.com
5.2.2 Fuselage tail - elevator pushrods and servos
Glue L1 and L2 parts of the stabilizer and elevator. The profile is symmetric, so the left and
right sides are identical. Glue the stabilizers perfectly perpendicular to the fuselage. Assemble
both sides of the elevator with the control lever on a flat surface. Make a Z bend on the
elevator 0,8mm pushrod wire. Using hot tool cut loose the hinge of the elevator on the F7
part of the fuselage and mount the elevator assembly to the stabilizer using the 0,8 - 1,2 mm
carbon rod or steel wire. Elevator should move freely controlled by the pushrod and servo.
Check the functionality of the elevator assembly carefully and finally glue in the rear rudder
part.
you will need: CA Glue medium viscosity+ activator
0,8 - 1 mm steel wire for elevator pushrod
0,8 - 1 mm carbon or steel wire for aileron hinge
Snap knife, Soldering Iron or any hot tool
See video guide #5
stabiliser L1
9,4g/0.33oz
(4,7g/0.17oz) LW
elevator L1
9,6g/0.33oz
(4,8g/0.17oz) LW
elevator L2
1,6g/0,06oz
(0,9g/0.03oz) LW
elevator arm
2,7g/0.09oz
stabiliser L2
1,8g/0.06oz
(0,9g/0.03oz) LW