User Manual

page 3
... print your plane | www.3DLabPrint.com
General specifications:
Length: 987 mm / 38,8 inch
Wingspan: 1320mm / 52,0 inch
Height: 330 mm / 13 inch
Wing area: 27,7 dm2 / 2,98 sq foot
Wing loading: 56,6 g/dm2 / 18,6 oz at sq foot
Center of gravity: 78mm (3,07 in) from LE
See CG tags on wings...
Airfoil: 3DLabPrint modified
Print weight: 970 g / 48.5 oz
Empty weight (w/o battery): 1300 g / 45.8 oz
Takeo weight (3s 3300mAh Li-Pol): 1570 g / 55.4 oz
Max takeo weight: 1650 g / 58.2 oz
Never exceed speed, VNE: 100 km/h / 62.14 mph
Design maneuvering speed, VA: 70 km/h / 43.49 mph
Stall speed, VS(full flaps): 24 km/h / 14.9 mph
Powerplant
Propeller: electro 9x6
Motor: Turnigy 3542/5 1250KV or similar
ESC: 40A Electronic Speed Controller
or similar 40Amps
Battery: Li-Pol 3000mAh/3s (11.1V),
at least 250g / 7.6oz, 25C
Performance measurement
Max speed VH (level flight): 105 km/h – 56.7kn – 65.2mph
with APC 9x6 E Thin electro
Rate of climb: 23 m/s (5 373 ft/min)
with APC 9x6 E Thin electro
Flight time (3s 3000mAh): 10:00 min