User Manual

page 21
... print your plane | www.3DLabPrint.com
Shopping list
Printing material: 1kg of PLA
RC: 5 chanell receiver by your RC system
Motor: Turnigy 3542/5 1250KV or similar
Controller: 40A Electronic Speed Controller
Battery: 3S Li-Pol 2700 - 3300mAh
Servos: 4x Hitec HS-82 or similar, size: 30 x 30 x 12mm servos
2x servo extension cables 300mm / 12 inch
Glue: CA Glue - medium or similar medium viscosity CA glue
Activator for CA Glue or similar,
Other: 1 mm / 14 AWG pushrod wire or carbon rod
2 mm carbon rod (small piece for tail wheel axis)
fitting screws